• Lane- or Edge-based Noise Measures
Lane- or Edge-based Noise Measures

The edge/lane based noise output based on Harmonoise writes information about the noise produced on edges/lanes. The model was generated within the EC-project Imagine. Its description can be found in the deliverable 18 of this project (D18 The Harmonoise Engineering model).

Missing

Add a model description here

Note

Please be aware that adding up noise is not as easy as calculating other emissions or consumption values because the perceived sound of two cars is not the sum of the volumes of the individual cars since the decibel scale itself is logarithmic.

Instantiating within the Simulation#

Edge-Based Noise Output#

An edge-based noise emissions output is defined way within an additional file as following:

<edgeData id="<DETECTOR_ID>" type="harmonoise" period="<PERIOD>" file="<OUTPUT_FILE>" [excludeEmpty="true"]/>

Lane-Based Noise Output#

An edge-based noise emissions output is defined way within an additional file as following:

<laneData id="<DETECTOR_ID>" type="harmonoise" period="<PERIOD>" file="<OUTPUT_FILE>" [excludeEmpty="true"]/>

Attributes, for both Edge- and Lane-Based Noise Output#

Attribute Name Value Type Description
id id (string) The id of the detector
file filename The path to the output file. The path may be relative.
period (alias freq) int (time) The aggregation period the values the detector collects shall be summed up. If not given, the whole time range between begin and end is aggregated
begin int (time) The time to start writing (intervals starting before this time are discarded). If not given, the simulation's begin is used.
end int (time) The time to end writing (intervals starting at or after this time are discarded). If not given the simulation's end is used.
excludeEmpty bool If set, edges/lanes which were not use by a vehicle during this period will not be written; default: false.

Generated Output#

Edge-Based Network States#

Lane-Based Network States#

Value Descriptions#

Name Type Description
begin (simulation) seconds The first time step the values were collected in
end (simulation) seconds The last time step + DELTA_T in which the reported values were collected
edge@id (edge) id The name of the reported edge
lane@id (lane) id The name of the reported lane
sampledSeconds s Number seconds vehicles were measured on the edge/lane (may be subseconds if a vehicle enters/leaves the edge/lane)
noise dBA The average noise generated by the vehicles on the edge/lane during the interval

Notes#

Notes:

  • Per default, all edges are written, even those on which no vehicle drove. It can be disabled setting the excludeEmpty attribute to true.
  • The interval end is the interval begin + aggregation time, meaning that values were collected within these steps excluding the end time itself. If the simulation ends before the last interval is over, the interval will be pruned.
  • The output file will be generated, does not have to exist earlier and will be overwritten if existing without any warning. The folder the output file shall be generated in must exist.
  • If you need only information about the network states during certain time periods, you may constraint generation of the dumps by giving attributes "begin="<TIME>\[,<TIME>\]+"" and "end="<TIME>\[,<TIME>\]+"". When at least one combination is given, dumps will be written only if an according begin/end-pair exists for the current time. This means, only those intervals will be saved for which begin[x]<=INTERVAL_END and end[x]>=INTERVAL_BEGIN. All dumps will cover the complete simulation if no values for begin/end are given.

See Also#