• Change Traffic Lights State

Change Traffic Lights State

---

Command 0xc2: Change Traffic Light State#

ubyte	string	ubyte	<value_type>
Variable	Traffic Lights ID	Type of the value	New Value

Changes the state of a traffic light. Because it is possible to change different values of a traffic light, the given value may have different types. The following values can be changed, the type of the value to given is also shown in the table.

Overview Changeable Traffic Lights Variables

Variable	ValueType	Description	Python Method
state (light/priority tuple) (0x20)	string	Sets the phase definition to the given. Assumes the given string is a tuple of light definitions from rRgGyYoO, for red, green, yellow, off, where lower case letters mean that the stream has to decelerate. After this call the program-ID of the traffic light will be set to "online" and the state will be maintained until the next call of setRedYellowGreenState() or until setting another program with setProgram().	setRedYellowGreenState setLinkState
phase index (0x22)	integer	Sets the phase of the traffic light to the given. The given index must be valid for the current program of the traffic light, this means it must be between 0 and the number of phases known to the current program of the tls - 1.	setPhase
program (0x23)	string	Switches the traffic light to the given program. No WAUT algorithm is used, the program is directly instantiated. The index of the traffic light stays the same as before.	setProgram
phase duration (0x24)	double	Sets the remaining duration of the current phase in seconds.	setPhaseDuration
complete program definition (0x2c)	compound (see below)	Inserts a completely new program.	setProgramLogic

The message contents are as following:

state (light/priority tuple) (0x20)#

string
Phase Definition (light/priority tuple)

state (phase/brake/yellow) (0x21)#

string	string	string
Green bitset	Brake bitset	Yellow bitset

phase index (0x22)#

integer
Phase Index

program (0x23)#

string
Program ID

phase duration (0x24)#

integer
Phase Duration [ms]

complete program definition (0x2c)#

byte	integer	byte	string	byte	integer	byte	compound	byte	integer	byte	integer	<phases>
value type compound	item number	value type string	program ID	value type integer	Type (always 0)	value type compound	Compound Length (always 0!)	value type integer	Phase Index	value type integer	Phase Number	Phases

with Phases:

byte	double	byte	double	byte	double	byte	string
value type double	Duration in seconds	value type double	unused	value type double	unused	value type string	State (light/priority-tuple)

Setting Traffic light parameters (0x7e)#

Traffic lights support setting of additinal parameters using the generic parameter setting call.

key	value type (expressed as string)	supported by tlType	description
cycleTime	double (s)	static, actuated, delay_based	default cycle duration (has no effect for static tls)
offset	double (s)	static, actuated, delay_based	offset for cycle start relative to simulation start
coordinated	bool	static, actuated, delay_based	whether time in cycle is computed relative to simulation time
max-gap	double (s)	actuated	detector time-out for abandoning phase
show-detectors	bool	actuated	show/hide detectors in view
inactive-threshold	double (s)	actuated	time-out for switching to an unserved phase when running with the default phase-skipping logic